How to Prevent Theft of Parts for Solar Powered Street Lights?

In response to national policies for energy conservation, emissions reduction, and the use of renewable energy, solar powered street lights have been chosen by many lighting project contractors as the primary construction product that perfectly complies with policy requirements. However, because the price of solar powered street lights is not cheap, it is very important to secure the anti-theft measures for each component of the solar street lamp. So, how should the components of solar powered street lights be protected from theft? Next, we will address this issue for you.

Since solar street lamps differ from ordinary road lamps and have a more sophisticated structure, the battery, circuit board, and other components are relatively expensive. Therefore, solar powered street lights actually have a value for stolen use.

The Battery of Solar Powered Street Lights Is Very Important

First, clean the soil and other dirt in the concrete slot where the battery compartment of the solar powered street lights is placed on the road base to ensure that there is no dirt inside the drainage pipe hole. Then check whether the battery compartment has been damaged, and also check whether the voltage of the car battery is normal. If any abnormality is found, it is a substandard product and is strictly prohibited from being installed.

Use insulating tape to wrap and protect the two aspects of the wire, disassemble the battery compartment, and lift it into the prepared road base with a crane. Then, after putting two double stainless steel wire clamps on the connected plastic hose, pass the battery wire through the prefabricated component pipe of the ground cage. Apply a layer of 7091 sealing silicone rubber uniformly on the prefabricated component pipe, and insert the other end of the connected plastic hose into the root of the prefabricated component pipe. Use a cross screwdriver to tighten the ground foot screw of the double stainless steel wire clamp.

After the battery wire is laid out of the prefabricated component pipe, wrap it in a plastic hose for wiring, and put two double stainless steel wire clamps on the plastic hose. Then, apply a layer of 7091 sealing silicone rubber evenly on the prefabricated component pipe, and insert the wiring plastic hose into the root of the prefabricated component pipe. Use a cross screwdriver to tighten the ground foot screw of the double stainless steel wire clamp, and finally fix the battery wire to the pipe.

Installation of Solar Powered Street Lights Power Generation Components

Battery and buried box: Because the solar street lamp battery is located around the highway, it is very easy to be stolen. The best way to prevent theft is to encapsulate it in a commercial use ground cage. The solar street lamp pre-embedded parts should be exposed to the road surface by 300mm at the upper end of the wire tube, and the surface should be combed and leveled to avoid the lighting fixture from being tilted.

The more precious maintenance-free gel battery is stored in the buried box of the China solar powered street lights and then placed in the ground pool about one meter apart from the road surface. After structural reinforcement, the battery will not be easily harmed by the surrounding environment because it is stored in the shell. In addition, from an anti-theft standpoint, it can prevent the theft of the battery.

Solar panels (solar cells): The solar cell panel is also a key component of the solar street lamp. Although the battery can be buried by the application party to ensure its safety, the solar cell panel presented to the outside world is very risky. In order to ensure that the solar panel is not easily stolen, technologically proficient manufacturers add some independent alarm devices to it. Once the solar cell panel undergoes unlawful disassembly, the alert system will be activated to prompt the application party to investigate.